Hudson Star Classic Cut Greensmower

Specs

• 82 lbs.
• Built with All Steel Frame
• Collapsible Tubular Handle
• All Steel Drive Train Guarded & Sealed
• Assembled Utilizing Stainless Steel Fasteners
• Sealed Bearings - No Lubrication Required
• Professionally Coated Parts for Corrosion Resistance
• 4 cuts per inch
• 16" Cut Width
• All manual mower with direct drive to reel

FAQ

Q: How much does the unit weigh?
A: The Classic Cut weighs 82 lbs.

Q: What is the cutting height range?
A: The cutting range for both units is 3/32" to 3/4". This allows for not only close golf course quality cuts, but allows trimming of fringe areas and tees as well.

Q: How hard is it to change cutting heights?
A: It is very easy. The full cutting height range is accessed by simply turning a single hand knob. There are no bolts or nuts to loosen or tighten. There is no adjustment from side to side.

Q: How many blades does the reel contain?
A: Both units are manufactured with an 11 blade reel. The reel is balanced and backlapped at the factory and gives approximately 4 cuts per inch.

Q: How easy is the Classic Cut to push?
A: Properly maintained, the Classic Cut is easy to push and can be used by women and even fairly young children. Conditions such as dull blades or excessively wet or tall grass will increase the force necessary and will effect the quality of cut.

Q: How often will sharpening be required?
A: Normally very infrequent. Conditions such as frequency of mowing cycles, condition of top soil, and frequency of top dressing can affect the condition of the blade. Both units come with a backlapping kit allowing the user to sharpen the cutting blades easily.

Q: Will the mowers catch grass clippings?
A: Yes! Clippings are collected in our unique molded catch can. The can "clips" on the front of the mower allowing quick and easy dumping and reattachment.

Q: How can I transport my mower from my garage to the green since I have to travel over concrete, asphalt, stones, rougher terrain, etc.?
A: Both mowers are manufactured with a unique multi-position handle assembly which allows the unit to be transformed into a transportation mode. Not only does it protect the cutting area of the mower, but it allows the unit to be used as a "smoothing" roller for the green.

Q: What about maintenance?
A: Under normal conditions little maintenance is required. All materials are powder-coated or manufactured from corrosion-resistant materials. All bearings are sealed and the drive-train is enclosed requiring no lubrication.

Q: Does the factory stock replacement parts?
A: Yes.

Q: Do the mowers come with a complete and detailed owners manual including identification of all replacement parts?
A: Yes!

Q: Should the mowers be cleaned after mowing?
A: Normally light spraying with a water hose and lightly coating with something similar to WD-40 is sufficient.

Q: What assembly is required when I receive the unit?
A: Simply bolt the handle in place. The mower is ready for the green.

Q: How long does it take to mow a green with these units?
A: Depending on the size and condition of the green, normal mowing time for most "home" greens would be approximately 10-20 minutes.

Shipping

Shipping is free!